View Single Post
  #4  
Old 05-31-2019, 02:57 PM
bivers bivers is offline
Junior Member
 
Join Date: May 2019
Posts: 3
Default

One way to accomplish higher resolution via the velocity outs would be via the sub sequencers. You can assign sub sequencers to the velocity out of any part in the "routings" page.

(see page 9 in the manual for more details)

This at least gives you 0-100 in terms of resolution. The drawback is that sub sequences can only be 8 steps max and they're slightly abstracted from the primary 'part'. It also appears that some of the handy editing shortcuts like holding SHIFT for coarse value changes haven't made their way into sub sequence editing yet.

Last edited by bivers; 05-31-2019 at 03:22 PM.
Reply With Quote