View Single Post
  #4  
Old 05-21-2019, 12:04 PM
jim jim is offline
Administrator
 
Join Date: Nov 2008
Location: Albuquerque, NM
Posts: 4,573
Default

Here are the full specs for mounting depth and power:

Vector: 42hp, 28mm deep, 140 mA on +12V, 20 mA on -12V

Expander: 12hp, 44mm deep, 30 mA on +12V, 30 mA on -12V

.. these are also listed on modular grid:
https://www.modulargrid.net/e/vendors/view/670

The Expander is too deep for regular mounting in the Pod60. I have seen folks use spacers to make it work, by raising the Expander about 10 mm higher than normal, but it is an unusual look.

Both modules will fit in a 60 hp Moog case, and you'd have enough hp left over for a power module.

The additional depth of the Expander vs. the Vector is due to the Expander being a two board 'stack'. One board has all the jacks, the other is a *very* dense board of SMD components.

Cheers,
Jim
Reply With Quote