#1
|
|||
|
|||
![]()
How deep are both modules? Will they fit in the 4ms pod60 (34mm deep)?
|
#2
|
|||
|
|||
![]()
looks fairly shallow in the pics at schneider's but i couldn't find actual data
https://www.schneidersladen.de/en/five12-vector.html ![]() ![]()
__________________
http://www.ignatiusmusic.com/ |
#3
|
|||
|
|||
![]()
Yeah that looks okay, it's the expander I'm worrying about. Would want to be able to mount them in the same skiff
|
#4
|
|||
|
|||
![]()
Here are the full specs for mounting depth and power:
Vector: 42hp, 28mm deep, 140 mA on +12V, 20 mA on -12V Expander: 12hp, 44mm deep, 30 mA on +12V, 30 mA on -12V .. these are also listed on modular grid: https://www.modulargrid.net/e/vendors/view/670 The Expander is too deep for regular mounting in the Pod60. I have seen folks use spacers to make it work, by raising the Expander about 10 mm higher than normal, but it is an unusual look. Both modules will fit in a 60 hp Moog case, and you'd have enough hp left over for a power module. The additional depth of the Expander vs. the Vector is due to the Expander being a two board 'stack'. One board has all the jacks, the other is a *very* dense board of SMD components. Cheers, Jim |
#5
|
|||
|
|||
![]()
Yeah and with the Expander, the quality of cable to connect to the main unit is very good and as such it is thick and adds a little depth. I found the expander didnt like being on the edge (left edge) of my Tip Top case. The Mantis cases have a bit of an indent that annoys some modules like Magneto.
|
![]() |
Thread Tools | |
Display Modes | |
|
|